CONTROLLERS & ADD ON MODULES

SMAC supply a variety of controllers and amplifiers to support their Actuators. The controllers allow code to be stored in non-volatile RAM which is then used to enable movements to be made in 3 different modes. These modes are desdribed in detail on the technical info page.

LAC1

A single axis controller with 8 TTL I/O channels, 3 analogue I/P channels and RS232 interface.

LAC25

A dual axis controller with 4 opto isolated I/O channels, 2 analogue I/O channels and RS232 interface. The LAC25 can be used to control either a single Linear/Roatary actuator or alternatively two independant Linear actuators. It is also necessary for grippers.

LAA5

A stand alone single axis amplifier which can be used in conjunction with any propriertary controller. It provides +/-10Volt I/P, 3amp O/P.

LAD1

The LAD1 is used to convert stepper inputs to 3amp servo output. This is particularly useful wherever a SMAC unit is retrofitted to, or integrated into a stepper driven machine.

MIO E - 8/8

If more I/O channels are required then the MIO can be linked to either the LAC1 and LAC25 to give 16 I/O channels.
Please note: This replaces the MIO16-R2

If you require more detailed specifications or drawings, please click on the link below and you will be redirected to our SMAC USA website.

SMAC INC HOMEPAGE